Linky: The meter emits 20 times less waves than the limit values ​​prescribed by law. 1

Linky: The meter emits 20 times less waves than the limit values ​​prescribed by law.

The national frequency agency (ANFR) published the results of the measurement campaign it carried out in 2019 near Linky smart meters in its annual study on Thursday, May 14, 2020. between Data collected at 287 locations close to the device (20 cm), indoors and mainly in urban areas. Measurements were taken at users’ request, as required by the national system for monitoring public exposure to waves in the 9 kHz – 100 kHz band.

ANFR’s conclusion is uncontested: all measurements performed comply with regulatory thresholds Public exposure to air waves determined by the decree dated 3 May 2002 and numbered 2002-775”. The measurements taken while sending data over the power line carrier (CPL) actually made it possible to observe once again two reassuring elements. Firstly these shipments and associated emissions are very short and extremely weak in terms of electromagnetic emissions..

Linky: These new measures confirm no health impact

So the shipments are final only between 0.1 and 0.2 seconds. Peak readings near the meter are therefore 3.7 V/m for the electric field and 0.25 µT for the magnetic field. While the legal limits are 87 V/m and 6.25 µT. This allows ANFR to say that the meter emits 20 times less waves at the peak than the regulatory thresholds.

Made in ANFR average measurements more than 6 minutes. Max levels then become unimportant with 0.96 V/m for electric field and 0.04 µT for magnetic field “90 times lower than regulatory limit values”, draws attention to ANFR. And to add that these levels decrease very strongly with distance: “‘The study shows that distance is an important parameter for exposure to waves. […] As soon as you move a few tens of centimeters from the radiation source, the exposure level drops sharply”.

Finally we learn that Linky meter emits very unevenly. Like this “CPL Linky radiation was not detected in half of the measurements despite an average measurement time of one hour”. ANFR explains that the interrogation interval of the counters depends on the number of connected counters. “in the same distribution cycle to serve a region”.

Linky meters have quite a few detectors that sometimes accuse it of inflating electricity bills, starting fires or causing health problems. Especially electricity sensitive people would like to be able to refuse its installation. It’s actually still possible to do. In some cases, the court also ordered the installation of an anti-wave filter.

However, as the number of measurements made increases, we understand that it is difficult to blame these meters – in any case on their own – having any effect on the health of those who install them in their accommodation.

Support our work ❤️

If you enjoyed this article, consider leaving a tip to help us keep publishing great content.

Secure payment on PayPal
Moyens I/O Staff is a team of expert writers passionate about technology, innovation, and digital trends. With strong expertise in AI, mobile apps, gaming, and digital culture, we produce accurate, verified, and valuable content. Our mission: to provide reliable and clear information to help you navigate the ever-evolving digital world. Discover what our readers say on Trustpilot.